Post 1 made on Wednesday September 16, 2009 at 09:20 |
dugan Long Time Member |
Joined: Posts: | December 2005 69 |
|
|
i have 2 cable dvr box's in the same area. 1 on projection system 1 on a plasma. The plasma box is located under stairs. Will this remote (s70) and a nevo connect work like the urc's. 1 in ir 1 in rf. or not use ir and tell the nevo or nevo connect what port i what box to controll. thanks
|
audio/video dave |
|
Post 2 made on Wednesday September 16, 2009 at 09:31 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,299 |
|
|
use ir for both. and setup the ir routing of the nevoconnect so that each cable box is controlled via different ports. in the software you will need to have two seperate devices that use the same set of ir codes. just name one device as "cable box 1" and the other as "cable box 2" then route the i.r for cable box 1 to a different port than cable box 2. if the cable boxes are close to each other, you may need to put some type of boot over the emitter so one doesnt interfere with the other.
|
|
|
OP | Post 3 made on Wednesday September 16, 2009 at 10:01 |
dugan Long Time Member |
Joined: Posts: | December 2005 69 |
|
|
Thanks DT.
|
audio/video dave |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.