Post 1 made on Tuesday July 21, 2009 at 16:00 |
Question,
I have a Nevo Connect and was wondering if I can plug a cable from one of the outputs into the input block of a Niles IR block (Niles RCA-HT2) – Is this possible? What I am trying to do –I upgraded my remote to RF but I still have keypads around the house which use straight IR into a Niles IR block. I want to avoid having to run all new emitters to all the components just for the new RF where the Niles has a empty input block – the input block has 4 leads to it and the emitters I think only have 2. Not sure if what I am asking for is even possible. Anyone?
|
|
Post 2 made on Tuesday July 21, 2009 at 19:25 |
sydinstaller Active Member |
Joined: Posts: | February 2004 740 |
|
|
Hi,
I have used a 3.5mm MONO plug from the NC-50 to a Xantech connecting block many times before.
Make sure you use a MONO plug and go to the INPUT side of the connecting block. You can have multiple IR inputs paralleled up. You need to connect IR and Ground.
D.
|
|
OP | Post 3 made on Wednesday July 22, 2009 at 10:56 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.