I need some help. I have an IR blaster connected to port 5 on my Nevo connect. It is attached to a USB receiver that is used with my MCE remote.

I added an IR device - Microsoft MCE Accessory and then connected the MCE Accessory to the configure connections in the Nevo Connect Ecosystem and checked the data out for port 5. I uploaded the new configuration and tested with no results. I then learned a button from my MCE remote, uploaded and tested with no results.

It seems I am not getting any signal to the USB receiver. I have to be doing something wrong. Any ideas?

Thanks for you help.

BTW... I did buy my Nevo from an authorized dealer and he did programing it. Just trying to get MCE going in my recently custom built HTPC without having to make yet another call to Sean.

Did you run an optimize?

No, I am not sure how to run an optimize or the purpose.

Here is MCE remote I am using. At first I thought maybe it wasn't an IR device but it according to this site.

[Link: acesuppliers.com]

With some research I found out this remote's usb receiver acts as a keyboard and mouse. Some of the key presses are interpreted as a keyboard press and some as a mouse. I am not sure if that is part of my problem. Maybe I should find a different way of going about controlling my HTPC. Any suggestions?

Never mind... I tried the learning functions again and they worked.