| Post 1 made on Monday April 27, 2009 at 16:47 |
Does anyone know if a 4 conductor extension is available to use between a Nevo video/voltage sensor and a NevoConnect (NC)? I want to install the NC by the equipment but the plasma TV is mounted on the wall and an extension between the two is needed, or I have to try and run two extensions from the TV (voltage sense and Ir emitter) to the sensor module located close tot he NC.
Thanks, mark
|
|
| Post 2 made on Monday April 27, 2009 at 22:12 |
Duct Tape Loyal Member |
Joined:
Posts: | November 2008
5,299 |
|
|
i always keep the voltage sensor near the nc50 and extend the emitter and voltage wires using cat5e. you might be able to find a cable to extend the plugs they use, but i wouldnt bother.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
