Post 1 made on Thursday April 23, 2009 at 13:45 |
Hello All,
Does anyone have any experience adding the Nevo (Q50 in this case) to an existing zwave network?
I have a customer who has an extensive zwave network controlled by homeseer home automation software, and needs homeseer to be the primary controller.
He wants to control the lights with his Nevo, and so far I've had very limited success. After a lot of wrangling around, I was able to add his remote and nevoconnect to the network as a secondary and static controller, respectively.
The remote can see all of the zwave devices, and even control them if you use the test mode on the remote.
However, I haven't been able to figure out how to get studio pro to see all of these devices that the remote sees. Do I need to add all of the lights as devices in studio pro, and then synch up the remote? Nevo's documentation on this part of the process is pretty limited so far. I checked out the videos on the dealer site and there's nothing to address this yet.
Any help?
|
|
Post 2 made on Thursday April 23, 2009 at 20:40 |
remoteshoppe Long Time Member |
Joined: Posts: | March 2005 484 |
|
|
Set up the devices in Nevo Studio Pro with logical names like Living Room Light, Kitchen light, etc and then go back into the Z-wave setup on the remote and you will be able to associate a Node with the device.
|
|
|
OP | Post 3 made on Friday April 24, 2009 at 18:49 |
Thanks,
I'll give it a try...
|
|
OP | Post 4 made on Friday April 24, 2009 at 19:05 |
That worked. Thanks so much.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.