Hi......hopefully someone can help me out! :)
I have just installed NSP on my laptop, it asked if I wanted the update....updated to 1.1.0.854 everything works fine. I also went to install it on another computer in my office and the original version on the desk works fine but, after the update when I go to open the program from the desktop shortcut the program starts and then stops. I reloaded the software three time and get the same results.
I was wondering if anyone has seen this problem before? I finally just left the software from the original disk install and started programming. Now if I work on a file on the laptop then transfer to the desktop in the office it always says I'm working with a file created in a newer version of NSP and says I should update the program to the newer version. I have registered the software on both PC's. Both on XP Pro the desktop is using much newer hardware than the laptop and is a much cleaner system.
Any help would be much appreciated.
Thanks
Rick
Last edited by RickS
on May 5, 2008 23:38.