| Post 1 made on Thursday January 24, 2008 at 04:21 |
Shmoo Lurking Member |
Joined:
Posts: | January 2008
2 |
|
|
I have recently added a SKY HD box to my installation. I already have 5 devices all working correctly via my NevoLink.
Problem is that when I added the SKY HD in NevoStudio it will not send the IR commands via the NevoLink.
However if I point the NevoSL directly at the SKY HD box it does change channels etc, so I know the codes are correct.
I know the IR emmitor works cause it works on other equipment.
All other equipment is being controlled fine via the NevoLink but not the new device.
What am I doing wrong? I have reset both the NevoSL and the NevoLink but the remote still outputs commands via its own IR output rather than via the NevoLink. Help!
|
|
| OP | Post 2 made on Thursday January 24, 2008 at 05:43 |
Shmoo Lurking Member |
Joined:
Posts: | January 2008
2 |
|
|
Ooops - The "Assigning a NevoLink to a Device" section of the design manual makes it all clear. Forget I said anything!!
|
|
| Post 3 made on Thursday January 24, 2008 at 06:06 |
sydinstaller Active Member |
Joined:
Posts: | February 2004
740 |
|
|
Cool.
Glad we could help :)
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
