i go to the add IR function and the wizard will only allow me to add a function by learning from the original remote... how do i enter a hex code?

Thanks, Chistian

Hi Christian -

I went into my remote file and just clicked on "ADD IR FUNCTION" and it gives me a choice of "learning" the function or entering a hex code. I select "Hex" and then a blank box appears for me to enter the hex code.

Ted

i'm going into the add ir function in the devices box. when i click on it the wizard window pops up and welcomes me to the add ir function wizard but there arent any options but to click "next". the next window promts me make sure my nevo is connected, again with the only option being to click next. where it there goes into learn mode.... ? is this a feature that was added with a recent update?

i'm thinking to upgrade to the latest version of NS 2.0..? it is saying i have to remove my previous version, should i do this? i dont recall having to remove it the last tiem i did an update.

any help is appreciated.

Hi Stealth,

Yes, completely uninstall the old version and install 2.0

If you tried to do an upgrade to 2.0 online, via Nevo Studio, once it recognizes you have another version installed, it usually halts the install and then puts a shortcout on your desktop, labeled "resume Nevo Studio install" or something close to this.

Give me a call if you need assistance. 650-591-2110

Good luck - Dave

The "Enter Hex Code" option was not available on the 1.2 NevoStudio version,

I found out that sometimes Hex code that I've copied from the ProntoEdit software could not be entered on the NevoStudio, an non acceptable Hex code message appears.

YEAH!! everything went as you stated Dave, the enter hex code option now appears in the add ir function widow, and it took a total of about 5min!

a thousand thankyou's for the help guys!!! (i know they arent QUITE as valuable as dollars-haha)

now i just hope the hex codes work. lol