Post 1 made on Sunday July 9, 2006 at 00:28 |
xincer Long Time Member |
Joined: Posts: | December 2004 11 |
|
|
I am finally getting much better response with my wireless network and the Nevo, or should I say, the Nevo is finally holding on to my network. The problem for me now is that the upgrade to version 2.0 made my NevoLink disappear. I can be seen as an unassigned Link from the remote and if I go into my router setting, I see it attached, but the NevoStudio will not see it anymore.
Any thoughts or suggestions? This is killing me. So close but yet so far.
Any help is welcome.
|
You can lead a horse to water, but you can't dunk its head. |
|
Post 2 made on Sunday July 9, 2006 at 09:38 |
icutfc Long Time Member |
Joined: Posts: | January 2006 192 |
|
|
Did you update the link? Did you build a new file for 2.0?
|
|
OP | Post 3 made on Monday July 10, 2006 at 00:40 |
xincer Long Time Member |
Joined: Posts: | December 2004 11 |
|
|
Update the link? New file? How do you update the link if you can't see it in the Studio program? Are you saying that the old file I had for my program of the remote has to be rebuilt for use with the new firmware and/or studio version?
|
You can lead a horse to water, but you can't dunk its head. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.