Has anybody else had problems with the battery only lasting a few hours after installing v1.2? Even with the WiFi set to Auto-Enable and max battery life I am lucky to get a whole day out of the remote.

Also, the battery does not charge sometimes when sitting on the cradle, even thought the blue light is on and the indicator is going up and down, when I take it off the cradle, the battery has not been charged any further. (only occasionally this happens though)

Any thoughts?

After v1.2, I'm actually getting better battery life. Before 1.2 I had quit using WiFI completely but now it's back on.

Perhaps your poor battery life and poor charging capability are more interrelated than you might think. Maybe you aren't getting a full charge for the same reason. Have you contacted tech support?

I'm having pretty good luck with the new firmware as well and I have updated several units already.

If I were you, I would definitely contact their tech support immediately.

"Has anybody else had problems with the battery only lasting a few hours after installing v1.2? Even with the WiFi set to Auto-Enable and max battery life I am lucky to get a whole day out of the remote."

REMINDER: Read the "NevoSL 1.2 Networking Whitepaper". You should never use the "Best Battery Life" option. There is one parameter set specified in the document. use that for best performance and check out section 5 for battery life.