Post 1 made on Tuesday May 10, 2011 at 15:11 |
Greetings,
I am programming a program with Nevo Connect Nc-50. When I download the complete code for a device,everything goes ok.But,when I learn a button by IR,on Nevo it responds as IR,I mean when I press it on Nevo from a far place (more than 10m) it doesn't respond because it's IR not RF or Z-wave!How can I learn buttons by Z-wave?
Thank you in advance,
|
|
Post 2 made on Wednesday May 11, 2011 at 06:54 |
brodyboy Long Time Member |
Joined: Posts: | April 2008 375 |
|
|
You don't learn commands by z-wave; Z-wave is just the way your remote communicates with the NC-50. You still learn an IR command with the remote, but then once it's in your NSP configuration, you need to set it up to go through the NC-50 rather than directly to the the target device. When you do that, the remote & NC-50 handle all the z-wave translations on their own.
|
|
OP | Post 3 made on Wednesday May 11, 2011 at 10:28 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.