| Post 1 made on Monday May 31, 2010 at 09:35 |
Nevo Q50
Can someone remind me how to set certain devices to IR while others on RF?
Where in the studio do i change that setting?
Thanks ...
|
|
| Post 2 made on Monday May 31, 2010 at 09:47 |
Duct Tape Loyal Member |
Joined:
Posts: | November 2008
5,299 |
|
|
in the Hardware section
click on the Nevo Ecosystem Tab
doubleclick on your nevoconnect
click on next
then assign each device to the port you have the ir emitter plugged into, or assign it to use the front blaster if you arent using external emitters.
|
|
|
| OP | Post 3 made on Monday May 31, 2010 at 22:06 |
Hi Duct Tape-
Im all set on the RF end - I forgot how to set a device (my AC) to IR.
Can i send an IR command out of the Nevo even though I have all other devices going to my nevo connect?
So for example all my audio video devices are controlled through my RF nevo connect - but my new-ly installed Mr. Slims i need to send an IR command to turn on and off ...
|
|
| Post 4 made on Monday May 31, 2010 at 22:23 |
Duct Tape Loyal Member |
Joined:
Posts: | November 2008
5,299 |
|
|
yes you can. just don't assign that device to any ports on the nevoconnect, and the ir commands will come straight out of the remote.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
