| Post 1 made on Wednesday September 18, 2002 at 17:46 |
RussRaff Lurking Member |
Joined:
Posts: | September 2002
1 |
|
|
I used to be able to do it, so why can't I now?
After getting half way through editing (using the latest versions of NeoEdit and firmware) a new Pronto Neo setup, I decided to save my work and shut down NeoEdit. I came back 30mins later to resume my tinkering and I can't add ANY buttons to ANY *.ncf file. I was adding buttons by dragging them from the gallery page, under the buttons tab, to the device page. Is this the correct method?
I have re-installed the software/firmware, to no avail.
Has anyone had this problem, or am I just being thick?
Russell
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
