Post 1 made on Saturday May 9, 2009 at 17:09 |
david fried Lurking Member |
Joined: Posts: | December 2003 8 |
|
|
I have seen where the learn process adds a second set of codes that mess with the program. What is the best way to clean the code after a learn? Thanks David
|
|
Post 2 made on Sunday May 10, 2009 at 08:14 |
Daniel Tonks Wrangler of Remotes |
Joined: Posts: | October 1998 28,780 |
|
|
Could you explain that one a bit more? What is causing you issues?
|
|
OP | Post 3 made on Sunday May 10, 2009 at 10:22 |
david fried Lurking Member |
Joined: Posts: | December 2003 8 |
|
|
Sure , I am programming my 501 using ncf files from the file forum. Then changing the hex with learning commands. Some times with the channel numbers I get extra numbers and so when I push the cnn icon I get 2022 instead of 202. I have tried longer waits and adding an enter command. But it is hit or miss. I have read that some times the code needs to be checked for extra redundant srtings? Am I making sense? Thnaks for any help? Also wondering how to get on/off trigger to the same button, only been able to learn the on to one button and the off to a second?
|
|
Post 4 made on Monday May 11, 2009 at 02:25 |
Daniel Tonks Wrangler of Remotes |
Joined: Posts: | October 1998 28,780 |
|
|
When learning, be sure to hold down the original button until the remote finishes learning. Don't just press the button briefly.
If your device has discrete power control on the original remote, that's what you have to use (unless you can find another code elsewhere).
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.