Post 1 made on Friday January 13, 2006 at 18:19 |
sgordon Lurking Member |
Joined: Posts: | October 2002 5 |
|
|
Hi all! I have a Pronto Neo that I've programmed to control my new Humax DRT800 DVR (w/DVD RW).
For the most part, I've used Learn mode to teach the Neo the new Humax codes without any problems. While teaching the Neo, I noticed that there is a light at the tip of the Humax remote that stays lit the entire time I have a Humax key pressed until it has been learned.
But there's one pesky key that can't seem to be learned. And of course, this is a key I really want...it allows me to jump back and forth between two channels while watching live TV. Oprah...Dr. Phil...Oprah...Dr. Phil. (Just kidding.)
What I noticed is that while I have this Humax key continuously pressed during Learn mode, the light on the remote only stays on briefly. Once it turns off, the Neo returns a learning failed message right away.
Does anyone know what this is about? Maybe if I understood what's going on, I could figure out how to get that IR code. (I haven't had any success yet searching the Files area.)
Many thanks! Sharon
|
|
OP | Post 2 made on Friday January 13, 2006 at 19:23 |
sgordon Lurking Member |
Joined: Posts: | October 2002 5 |
|
|
Never mind! I was able to find the code from an ncf in the Files section. (Although I'd still be curious to hear the seemingly different "broadcast" length of different buttons on the same remote. What's the reason for that?)
Sharon
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.