| Post 1 made on Friday July 23, 2004 at 08:58 |
Has anyone managed to get an Infocus 5700 projector to work with the RU930 unit? I have looked at Neohacker but I can't quite figure out how to use to check to see what codes have been learnt. The RU930 learns the code set, but the 5700 will not respond to any commands from the RU930 unit - any suggestions would be most welcome - thanks.
|
|
| Post 2 made on Saturday July 24, 2004 at 07:14 |
Springs Super Member |
Joined:
Posts: | May 2002
3,238 |
|
|
5700 uses the same codes as the 7200. There are some in the descrete section. They are 100%
|
|
| OP | Post 3 made on Monday July 26, 2004 at 05:03 |
Thanks springs - I found the unit does learn the codes OK, but seems to mess them up when you up load to NeoEdit and then downlaod them back again - still investigating the problem, but if I teach the unit after a download, the codes work OK, must be a bug in the software somewhere?
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
