Programmed HP65 dlp rp tv, DVDO hd, Bose GS II receiver with a Tivo HD receiver that is on all the time.
Each Macro works great individually for each device except TV on. When I macro the ON button to Turn on TV, DVDO and Bose unit, all work fine except the TV doesn't turn on. I have tried Learn commands on both the PC and the remote itself and no change all work except the TV. On the OFF macro using the off button everything turns off as programmed. I have tried copying the P-Off command since they are initially the same button on the original remote, but it will not turn On. A side note. Once the TV is on (push TV MANUAL ON button) all TV on commands work. Can't figure this one out. Any suggestions..Thanks

This is a problem specific to these HP TV's. As far as I know URC has no fix for this yet and evidently admits it's something they need to resolve. As a side note you may have also noticed that the TV will not power on reliably from the MX remote depending upon if the TV is cold.

Tweeter Guy is absolutely correct, it's the HP TV after the power is ON everything works perfectly, even the power ON & Off buttons. So for all of you out there, just go up to the HP TV and push the power button manually or use the orignial remote to power on and then run your MACRO. Works great. Finally got a remote my wife likes?