Post 1 made on Monday August 29, 2005 at 21:17 |
SJHart Long Time Member |
Joined: Posts: | December 2003 383 |
|
|
Have a question about my MX3000 and IR/RF. If I have a two devices listed (in the programming) and have a button on one of the devices which references a button on the other device, does the RF control follow what I have setup for the second device. For example, Device 1 I have setup as IR/RF, Device 2 I have setup as RF only. If I access the second device from a page of Device 1, does it only send RF or IR/RF? The button on the Device 1 is a reference(alias) to the Device 2 page. Thanks. SJ
|
|
Post 2 made on Monday August 29, 2005 at 23:59 |
Ericjb Active Member |
Joined: Posts: | February 2004 655 |
|
|
The IR/RF assignment follows the device where the command actually exists. Therefore in your case the command you alias actually resides on Device2 which is RF Only the command will be sent out RF only. If you want to send it out IR, you would need another device assigned IR only and place the commands there, then alias them from wherever you want.
The beautiful thing about the MX-3000 is that you can create an IR only device with no ability to directly access the device itself, but you could just alias commands from other pages. making it relatively transparent.
|
There are 10 types of people in this world, There are those who understand binary, and those who don't! |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.