| Post 1 made on Thursday August 25, 2005 at 11:26 |
markeetaux Founding Member |
Joined:
Posts: | March 2002
14 |
|
|
I just dusted off the old SL-9000 remote. Replaced the batteries, and began
programing for my new plasma and Dishnetwork 811 HD receiver.
Everything went fine until I tried to designate the "POWER" button as the
memory button to execute my turn on of both the SAT and TV units.
I can successfully use any other memory button (M1-M4) but not the "POWER"
button.
Any advice or help would be appreciated. Thanks in advance.
This message was edited by markeetaux on 08/25/05 11:57 ET.
|
|
| OP | Post 2 made on Tuesday August 30, 2005 at 22:04 |
markeetaux Founding Member |
Joined:
Posts: | March 2002
14 |
|
|
So I'm the only one that has had a problem programing the power button on
the SL-9000 as one of the five memory buttons?? I'm also the only one with a
problem transfering the "FORMAT" code from the Dishnetwork 811 receiver
to the SL-9000??
Other than battery replacement, is there any HELP out there??
|
|
| Post 3 made on Tuesday August 30, 2005 at 22:23 |
edmund Elite Member |
Joined:
Posts: | April 2002
13,841 |
|
|
|
| OP | Post 4 made on Tuesday August 30, 2005 at 22:44 |
markeetaux Founding Member |
Joined:
Posts: | March 2002
14 |
|
|
Thanks Edmund, I'll try it in the morning. I'll let you know how it went.
Thanks again,
Mark
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
