| Post 1 made on Wednesday August 17, 2005 at 11:41 |
I have an ACT-3 Acurus pre-amp for which the remote is lost. I downloaded the ACT-3 codes for my MX-700 and was trying to teach the codes to my MX-500. The MX-500 has trouble learning the codes according to how long I hold the buttons down on the "sending" unit to the "receiving" unit. Some codes are learned well and some have to be taught over and over again adjusting how long I hold down the sending buttons. Is this unusual?
|
|
| Post 2 made on Wednesday August 17, 2005 at 14:50 |
Surf Remote Loyal Member |
Joined:
Posts: | July 2001
5,958 |
|
|
Not really. Some commands are difficult (if not impossible) for the MX-500 to learn. Typically, you only want to use a single push of the button on the remote you're learning from. You hold it down or "flutter" it to learn commands you want to repeat (like Volume or Channel Up/Down). Mike www.SurfRemoteControl.com
|
www.SurfRemoteControl.comTHX-certified video calibrator and contributing writer, ProjectorReviews.com |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
