Post 1 made on Thursday December 21, 2000 at 11:30 |
I am trying to use the MX1000 to control an RCA S-video splitter. I have buttons setup that properly change the splitter when they are pressed. My problem is that when these same buttons are used to create a macro the RCA device is not recognizing the signal. Is ther some method to force a macro to perform the same function of "pressing a key for a couple seconds". I think the RCA device just requires a bit more time to react. I have tried "pause" commands as well as multiple key presses. None work. This is the only device in my entire configuration that I am having problems with. Can someone help!!! I'm so close to a perfect solution.
|
|
OP | Post 2 made on Friday December 22, 2000 at 10:48 |
During the programming of a macro each press of the Volume up button adds a half second delay before the next command is sent. Perhaps your device just needs more time to react before another command. Worth a try anyway.
|
|
OP | Post 3 made on Monday December 25, 2000 at 10:28 |
Jeff C Historic Forum Post |
|
|
I tried that but it still does not work. Even if I lightly press the key and hear the beep, the device does not respond. However, if I press and hold the key for a second or so the device correctly changes.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.