| Post 1 made on Sunday November 5, 2000 at 12:25 |
Geoff Amthor Historic Forum Post |
|
|
I'm about to program my MX-1000 to handle my 2 Tivos (Philips standalone and DirecTivo) and DirecTV receiver (Sony). Any tips on programming codes, best device template to start with, programming hard buttons/joystick, etc.? Thanks in advance.
|
|
| OP | Post 2 made on Monday November 6, 2000 at 14:40 |
Ron Barr Historic Forum Post |
|
|
I use the built-in SAT configuration for my DirecTV (it's a Sony a50) and it works fine.
FOr Tivo, I learned all of the joystick commands from the remote and made select "press" on the joystick. I learned play, ff, rew, and stop (pause), and I learned "prev ch" as "jump back 8 seconds, jack!" I then made a single screen with tivo, guide, thumbs up & down, clear, end, and enter. It works fine; the only flaw is I have to change screens to enter numbers.
I'm eager to see what others come up with.
Ron
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
