Your Universal Remote Control Center
RemoteCentral.com
URC's Consumer Remotes Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
MX-900 programming
This thread has 1 response. Displaying all posts.
Post 1 made on Thursday November 10, 2016 at 15:47
JT5298
New Member
Joined:
Posts:
November 2016
2
Hello, I have and MX-900 and would like to set up a macro for turning on and off zone 2 when I power on the receiver. The reason for this is I have an external amp and the Onkyo receiver does not have a 12 volt trigger for zone 1. The amp has a 12 volt trigger going to zone 2 and I would like to be able to turn on and off the amp when I turn on and off the receiver. I could probably figure it out by going through the review on this site but I'm wondering if I need to use the "variables" option.

Thanks
OP | Post 2 made on Friday November 11, 2016 at 09:47
JT5298
New Member
Joined:
Posts:
November 2016
2
Got it figured out. Thanks anyway.

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse