| Post 1 made on Sunday September 27, 2009 at 13:43 |
I know I am not alone outthere but I have not been able to find a solution that worked so far.
I got Uverse installed yesterday, and used "LEARN" for all the buttons on the MX-500 to operate the Motorola box. However, none of the buttons worked on MX-500 for the Motorola box. Remote happily learned (said "GOOD" for each button) all codes the ATT remote fed it but box did not react at all.
I did a bit of research, and found a post here that says that ATT remote sends some junk along with the code so "you have to wait 2 sec before learning the command on MX-500". I tried that and - miracle - the "Recorded TV" button got learned and worked off MX-500. However I could not get any other buttons programmed this way.
There were other posts that outlined the codes that the box expects but I dont believe there is any way to enter hexadecimal codes into MX-500 since it does not have a PC connection.
So - has anyone reliably resolved this and programmed MX-500 for Uverse's Motorola box?
Alternatively, what other remotes do you use with the box that work well?
THANKS!
MT
|
|
| Post 2 made on Thursday October 15, 2009 at 21:26 |
Hecdaman New Member |
Joined:
Posts: | October 2009
3 |
|
|
|
I have a MX-500 and had Uverse installed month ago. I programed in everything by following the manual's instructions and all is well. I suggt you try again with a different Uverse remote. If this does not work than there maybe someting wrong with the learning feature of the MX-500.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
