Post 1 made on Monday December 24, 2007 at 13:22 |
tkc9789 Long Time Member |
Joined: Posts: | November 2004 38 |
|
|
Hi, I'm trying to setup a macro for powering up my HT (receiver, dvd player and TV). The receiver takes about 10 seconds to complete the cycle up. Do I have to hit the "pause" key 50 times to allow for the cycle up time? What's the maximum pause allowed?
Thanks.
|
|
Post 2 made on Monday December 24, 2007 at 13:47 |
8ate8 Advanced Member |
Joined: Posts: | November 2005 778 |
|
|
Does your receiver remember what input it was on after you turn it off? In your off macro, tell the receiver to go to the input you want for the next time you turn it on. Do the same for your TV. This way your on macro is just tv on, receiver on, dvd on, and you're done.
|
|
OP | Post 3 made on Monday December 24, 2007 at 13:58 |
tkc9789 Long Time Member |
Joined: Posts: | November 2004 38 |
|
|
The receiver does remember the last input. But I have multiple devices connected to the receiver. The last input is not necessarily "DVD". In additon, I wish to adjust center channel level for movies..... That's why I need for the receiver to complete its power up cycle which takes about 9 or 10 seconds.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.