Post 1 made on Friday August 3, 2007 at 07:14 |
Hi,
How can I program my MX-500 to control three different Dish Network receivers? Right now, the remote controls all three simultaneously. Are there individual hex codes or something similar to distinguish one receiver from another?
Thank you
|
|
Post 2 made on Friday August 3, 2007 at 11:47 |
edmund Elite Member |
Joined: Posts: | April 2002 13,838 |
|
|
dish receivers have 16 remote addresses, but the only one preset into the mx-500 is address #1. See your manuals on how to switch the receiver to alternate codes, and then teach them to the mx-500.
|
|
Post 3 made on Friday August 24, 2007 at 11:40 |
WC Anderson Long Time Member |
Joined: Posts: | November 2004 139 |
|
|
I currently have an MX-500 and a MX-350 that operate five Sat receivers (Bell) each.
You need to do the do these one at a time. To save a lot of grief unplug the sats that you are not programming. To change the sat remote address use the original remote. LABEL each of your sats as Remote Address 1, Remote Address 2 and Remote Address 3.
Take the original remote and turn on the sat. Press and hold the SAT button on the remote till all lights flash. press the 2 button then the # button.
Voila that sat is now programmed as remote #2. Now learn the MX from the original. Then do sat three.
Good luck!!!
|
I prefer RTI - THEY ACTUALLY WORK!!! Harmony 610 (wife) & three RTI T4 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.