Post 1 made on Thursday April 5, 2007 at 23:49 |
jls944 Long Time Member |
Joined: Posts: | February 2006 55 |
|
|
Can the MX-900 control lighting (preferably z wave)? Also, does the remote allow you to create macros with lighting configurations in them? For instance if I press "Watch TV" the following actions occur:
Television turns on A/V Receiver turns on Cable box turns on Lighting dims to preset level (does the lighting come on to the preset level or do the lights ramp up/down to the level?)
Any help would be appreciated. Thanks.
|
|
Post 2 made on Friday April 6, 2007 at 01:19 |
OTAHD Super Member |
Joined: Posts: | October 2005 4,679 |
|
|
It cannot direcly interface with Z-wave. If there is some way to get Z-wave to accept IR, then yes.
X-10 does have IR receiving modules.
|
LET'S GO BUFFALO!!! |
|
Post 3 made on Friday April 6, 2007 at 02:29 |
pilgram Loyal Member |
Joined: Posts: | November 2004 5,684 |
|
|
The remote will control anything that can be controlled with IR. I'm using Lutron spacers and it works just like you stated. If you back up a page, you can also adjust the light up or down, or turn them off or on.
|
Every day is a good day.......some are just better than others!
Proud to say that my property is protected by a high speed wireless device! |
|
OP | Post 4 made on Friday April 6, 2007 at 09:55 |
jls944 Long Time Member |
Joined: Posts: | February 2006 55 |
|
|
thank you. I do want to stay with z wave, and unfortunately they don't accept ir commands.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.