Thanks for the reply, is the IR Hex the code that reads like 00010101010110101010101 etc that can be copied and paste - it would be great if the other pronto remote software had my PC IR Codes and i could just copy and paste them in...
I was gonna post on Soundgraphs forum, so i'll try that if all else fails.
I tried learning from both the soundgraph remote and the 885... the 885 fails everytime, but the soundgraph says 'learn succesfull' but upon testing the learnt button, it doesn't work or very delayed....
I'm running vista, the power button on the ipronto boots up the pc from cold but the IR on the PC is very low down, about 8" off the floor.
I don't want to turn the epg off, very happy with that and it downloads fine, but every morning, the remote trys a auto firmware update and can't connect to boot.pronto.philips.com
Thanks again for the reply.....
On August 6, 2008 at 16:42, Grimmace said...
Issue 1: A couple of things to try
- See if other Pronto remotes have the device and get
the IR Hex codes from them
- Have you emailed soundgraph and asked if they will give
you the IR codes?
- Try learning with different lengths of pressing the
original remote buttons and distances. Make sure you have
low light. Try learning from the 885 instead of the soundgraph
remote. If the 885 did well, copy that.
- Also you just listed the case, not what the computer
is. Are you using XP or Vista? Where is the IR port? Is
is positioned well? Are you using the IPronto or the IR
Issue #2: Try to do a manual update when connected and
see if that will stop the automatic attempts. What version
of firmware is loaded? You cannot turn the EPG off.