Post 1 made on Tuesday May 18, 2004 at 09:36 |
Hi:
I recently converted from a prontopro that was working perfectly....to an iPronto. Some of the buttons that were working well on prontopro are much less reliably on the iPronto. Some require at least 2 or 3 presses before the command will finally work. It is rather sporadic...some screens work perfectly...others not.
This had made a number of macros work only intermittently. I've tried "learning" the buttons from the original remote and the prontopro. And i've even tried cut and pasting codes.
Any suggestions to improve reliability would be appreciated.
|
|
Post 2 made on Tuesday May 18, 2004 at 12:57 |
Kees van der Meer Long Time Member |
Joined: Posts: | December 2003 162 |
|
|
HarryB, Check this out: [Link: remotecentral.com]Maybe useful for you too. Regards, Kees
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.