Post 1 made on Thursday April 29, 2004 at 11:16 |
bobbbird Long Time Member |
Joined: Posts: | April 2004 29 |
|
|
I'm just learning to program the 6400 having worked with the 3000 and 2000. I'm having a problem with buttons that should repeat. On my TV the vol up works fine but the vol down requires that I sit and hit the button many times to get a little change. My preamp requires multiple button presses to provide any real change. Both were were programed from the actual remote.
Also
I have one device that works under IR control from the 2000. Although the 3000 will learn the comands, It will not control the device. I have tried doing a copy/paste from the 2000 editer and that doesn't work.
Bobb Partridge
|
|
Post 2 made on Thursday April 29, 2004 at 12:00 |
Kees van der Meer Long Time Member |
Joined: Posts: | December 2003 162 |
|
|
Could it be an out-of-range question? Did you test the IR performance directly in front of the receiver? Maybe dirt is the problem and a little cleaning of the IR-receiver will help (you never know...)
Kees
|
|
OP | Post 3 made on Thursday April 29, 2004 at 12:43 |
bobbbird Long Time Member |
Joined: Posts: | April 2004 29 |
|
|
Thanks Kees,
Both of the device remotes work near the devices and from a distance.
The 6400 does not work from either place.
bobb
|
|
Post 4 made on Friday April 30, 2004 at 02:47 |
Daniel Tonks Wrangler of Remotes |
Joined: Posts: | October 1998 28,780 |
|
|
Re the repeating problem, try learning the codes again - hold them down until the iPronto finishes learning (if you just press the button, the remote captures a code that's just a single press and won't repeat).
|
|
OP | Post 5 made on Friday April 30, 2004 at 11:19 |
bobbbird Long Time Member |
Joined: Posts: | April 2004 29 |
|
|
Thanks for the hint,
I tried rereading the repeating buttons as per your suggestion. One worked and the other still required multiple presses. Upon looking at the codes in the editor I found that the failing one had a .1 sec delay before it while the working one was undelayed. Removing the delays made all of the buttons work correctly.
I still am unable to get the Mp3 codes to work at all.
bobb
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.