On 03/20/03 13:27, ChrisKober said...
I just got my iPronto yesterday everything connected
fine and the setup went good. Except 3 things..
1. My EPG wont update fully. It gives an error
and says it will try later.
2. Sometimes I cant power off the unit with the
side button. Then if i go to the back menu and
choose reboot. It says unable to reboot try later.
So I then have to use the stylus to reset the
3. I programmed the screen buttons and hard buttons
with my original remote. But when you want to
say change channels you have to press the button
and actually keep it pressed for it to change,
you cant just tap it likr the tsu2000. Same goes
for the hard buttons. it clicks but sometimes
wont change. If you want to go up 2 stations you
have to pressss, let up pressss... Some what of
a pain. Im wondering if its the iPronto itself
or the Firmware...
Anyone else expierence this?
I've heard similar things about the firmware. Regarding your problems with sending learned IR codes, I had a similar problem. Learned the code, works, but does not repeat. I found that when you keep the button pressed longer while learning untill it says succeeded, the code does repeat. Works fine now.