Your Universal Remote Control Center
Philips iPronto Forum - View Post
Previous section Next section Previous page Next page Up level
Up level
The following page was printed from


Page 2 of 2
New install-EPG will not load
This thread has 17 replies. Displaying posts 16 through 18.
OP | Post 16 made on Thursday December 18, 2003 at 09:22
Long Time Member
December 2003
On 12/17/03 08:37, igotcoolstuff said...
I purchased a Belkin54G access point last night,
pluged it in, unplugged the linksys stuff, set
the ip's to the same as my Linksys WAP11 and ...............

I'm using a Linksys WAP plugged into an OnQ router. Are you saying that this was a hardware conflict issue??
Post 17 made on Thursday December 18, 2003 at 20:51
Founding Member
August 2001

since the brand change no problems at all .. all this time i was thinking i was doing something wrong with the pronto or its set up. With the wap11 network i tried for three days to configure my netX's thinking i was doing something wrong... this is my first ipronto ... since the access point change , its a whole new game, my netx's both work great,configed first shot (it wouldnt even let me change their names before) my EPG loads and after only two days seems fine too. before the iprontoedit never even saw my pronto on the network nor could it "autodetect" the netX. to download the config file i was typing in the fixed ip I had it set to. Now the software "sees" it from the upper download box.

so hopefully it will keep on truckin .....

only time will tell ..

Post 18 made on Sunday January 18, 2004 at 12:41
Lurking Member
January 2004
Now WLAN works
after days working arround above problems and updating all devices it works now for two hours.
Using D-Link DWL900AP+
set speed to 10MB, using DHCP,using encryption, set the DWL900AP+ to MAC Filter function on (Typing the MAC addresses of the iPronton and other WLAN clients.
I dont know which one was the good one but it still works, loaded the complete EPG (before it was corruptetd)an I, still connected.
Page 2 of 2

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse