Your Universal Remote Control Center
Harmony Remote Controls Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Cisco DVR power on/off to toggle
This thread has 1 response. Displaying all posts.
Post 1 made on Sunday May 1, 2022 at 07:16
New Member
May 2022
I'm trying to set up a Harmony Elite to operate a Cisco DVR. Everything works fine, except it does not turn on and off correctly. The "Power On" and "Power Off" commands don't do anything, only "Power Toggle". How can I fix it? I would prefer to use the on and off commands, but I can't even figure out how to change both to toggle!
Post 2 made on Friday May 6, 2022 at 20:36
Daniel Tonks
Wrangler of Remotes
October 1998
Sadly, last time I checked Cisco steadfastly refused to add discrete power commands. You can check the setup menu to see if there are any power on options that might allow you to turn it on by pressing a number key, for example.

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse