|Post 1 made on Saturday December 30, 2017 at 16:15 |
So here is my situation I received a harmony elite for Christmas to use with my basement setup and needless to say it's like trying to fly an airplane for the first time. I seem to have done really well and have 90 percent of my equipment set up. My biggest challenge that I cannot figure out is I have three tv's all next to each other with two of them controlled by dish wireless Joey and the other controlled by the dish hopper, when I try and use the commands for one it performs that command to all. How do I get the harmony remote to distinguish between each cable receiver. The only receiver that gave me a pairing code was the hopper the two joeys both say they are connected to my internet router but no pairing codes show up I am lost.
Thank you for your time
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.