Your Universal Remote Control Center
Harmony Remote Controls Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Harmony elite and dish network help
This thread has no replies.
Post 1 made on Saturday December 30, 2017 at 16:15
Junior Member
December 2017
So here is my situation I received a harmony elite for Christmas to use with my basement setup and needless to say it's like trying to fly an airplane for the first time. I seem to have done really well and have 90 percent of my equipment set up. My biggest challenge that I cannot figure out is I have three tv's all next to each other with two of them controlled by dish wireless Joey and the other controlled by the dish hopper, when I try and use the commands for one it performs that command to all. How do I get the harmony remote to distinguish between each cable receiver. The only receiver that gave me a pairing code was the hopper the two joeys both say they are connected to my internet router but no pairing codes show up I am lost.

Thank you for your time

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse