| Post 1 made on Monday November 17, 2014 at 00:55 |
Steve Westcott Founding Member |
Joined:
Posts: | October 2001
59 |
|
|
I replaced an old 890 with a new one, along with the RF receiver and renamed them both as "New 890" and "New RF Receiver". Even though I have deleted the old ones every time I need to update my remote/receiver, the old equipment shows up again. I then need to stop the update, delete the two old pieces, and then start the update again. Next time I tweak something and need to update, there they are again. How do I make them disappear for good?
|
|
| Post 2 made on Monday November 17, 2014 at 15:07 |
rehaz1 Active Member |
Joined:
Posts: | December 2005
522 |
|
|
When you replaced the 890, you should have just used the Replace Remote option in the Harmony software. Are these 890s the 890 Pro by chance? with the 890 Pro, you could have up to 6 890 Pros in one account. With the 890 Pro, unless you permantly deleated the remote from your account, by naming the new remote "New 890", you never deleted the old remote from yopur account, and everytime you do an update it will look for the opd 890 to update it and the extender.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
