Post 1 made on Sunday October 13, 2013 at 08:10 |
WilkeE Lurking Member |
Joined: Posts: | October 2013 1 |
|
|
My Home Cinema set LG has a number of inputs. Two of them HDMI. I have two devices connected: A Amino 540 (decoder for the fiber TV signal) to HDMI-1 and a WD TVlive for the streaming from my NAS on HDMI-2.
The Remote switches fine to HDM-2 when I select e.g. music streaming from the NAS. But not back to HDM-1 when I select Watch TV. Even switching everything off does not help.. Despite that in the Watch TV activity I programmed HDM-1 as input for the LG. So now I have to get the LG remote, and manually switch back to HDM1. It just looks like the Harmony does not have a correct code for the HDMI-1 on the LG?
I used the MyHarmony on the Internet for programming the Remote.
Any help would greatly be appreciated !
WilkeE
|
|
Post 2 made on Sunday October 13, 2013 at 11:07 |
rehaz1 Active Member |
Joined: Posts: | December 2005 522 |
|
|
Press and hold the Help button on the 700 for 5 seconds to get to the Advanced setting area increase the inter-device delay for the Home Cinema to fix the problem when switching between activities, and increase the Power On delay for the Home Cinema to fix the problem when starting from an all off state.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.