Post 1 made on Friday September 27, 2013 at 01:37 |
Hi,
I have an RTI RCM-12 IR Relay module that I need to control with a Harmony Ultimate. I had someone lend me an RTI TC2 remote with the relay controls programmed in, however when I try to teach them to the Ultimate it doesn't take. I have tried pulsing and holding the buttons down. I thought the RTI might have too strong of an IR signal, so I tried holding the RTI remote 6 feet away and gradually coming in closer.
No cigar...any thoughts?
Alternatively if there is a way to program the codes directly in that would be tops.
|
|
Post 2 made on Friday September 27, 2013 at 14:31 |
Daniel Tonks Wrangler of Remotes |
Joined: Posts: | October 1998 28,779 |
|
|
Are you sure the RTI is set to transmit IR?
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.