Your Universal Remote Control Center
RemoteCentral.com
Harmony Remote Controls Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
Harmony ONE not choosing correct input at start up
This thread has 3 replies. Displaying all posts.
Post 1 made on Wednesday August 29, 2012 at 02:34
crazymorton
Long Time Member
Joined:
Posts:
January 2008
10
I made some temporary changes to my ONE during a lounge room reno where i had to disconnect some devices as we were watching TV in the dining room while we painted.

This eliminated my HT for a while so i re cabled and created a couple of temp activities. Now my TV & Xbox went direct to different HDMI inputs. Watch TV switched to HDMI2, and Xbox to HDMI3.

Previous they were both through my HT via HDMI 1 output on the TV.

Now we are done and i put it all together again but I have this problem. I deleted the temp activities and am using the original ones for both WatchTV and Xbox but the TV input on start up keeps cycling through HDMI. Even after i turn it off on HDMI 1 the next restart the signal is obviously making it go to the next input. It's an LG50PG60UD.

Any tips on how to fix this please? I just want HDMI 1

thanks
TV: LG 50" LG50PG60UD
PVR: Topfield 7000HD PVRt Amp: Pioneer VSX-816 Speakers: 5.1 Dream Hi-fi (Dream CX-12 Sub)
Xbox 360/Wii/Harmony One/iPad2
Post 2 made on Wednesday August 29, 2012 at 16:16
jlet
Super Member
Joined:
Posts:
March 2004
2,631
Check you TV device "inputs settings" (under Devices > Settings > Adjust inputs) and make sure Method 2 (discrete method) is selected. Method 2 is the default for this TV model (LG 50PG60UD). It sounds like it got change to one of the other cycling methods. Then click next (x2) to check if the correct commands are mapped to the correct input labels. If this is okay, then check that the TV is set to the correct input in your TV activity(ies). Else, it could be a timing issue. Check the TV device speed settings (under Devices > Settings > Adjust the delays). You may need to increase the Inter-Device Delay.
H659, H680, SA8300HD, TH-50PZ850, AVR-X4000
Post 3 made on Saturday September 1, 2012 at 18:45
rehaz1
Active Member
Joined:
Posts:
December 2005
522
If the TV is not selecting the correct input at startup, and the OP is using Method 2 and the correct commands are assigned to each input, then he needs to increase the Power On delay for the TV, not the Inter-device delay.
Post 4 made on Tuesday September 4, 2012 at 18:09
jlet
Super Member
Joined:
Posts:
March 2004
2,631
Very good point.
H659, H680, SA8300HD, TH-50PZ850, AVR-X4000


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse