On January 26, 2012 at 17:32, jlet said...
Use the Activity custom Start/Exit macro (sequence of commands) feature. Review the settings for the Activity (under Activity > Settings), and select "Yes, but I want to add more control of options and devices for this Activity". It will go through the setup again, just click next/save a few times until you get to the custom actions configuration page where you can add sequence(s) of command(s) to run at Activity Start (Start Action) and/or Activity Exit (Leave Action).
Thanks but the issue I see running into is:
Currently the only way I can think of to do this sequence to go from say General scene to Game Scene is the following -
command -Scene
command - direction up
command - direction up
command - direction up
command - select
(to get from game to custom just change the ups to down)
The issue is everytime I turn on the TV with that activity regardless of where it was last set for scene mode it's going to run that command regardless. Say I do play video game, it changes the scene from general game and i play a bit and power down, then later i decide to play video game it's going to go off game mode and up 3 and select that mode (I think it would be movie) and then everything is off.
I just wish there was a discrete code to select a particular Scene mode or a different option for selecting scene. Of course this doesn't even begin to take in account the picture mode under that scene.
Any suggestions?