Just got the 1100 for Christmas...awesome so far. I found your link to your page for the icons which would be very helpful but it seems the page is down :(

"Service Temporarily Unavailable
The server is temporarily unable to service your request due to maintenance downtime or capacity problems. Please try again later.

Additionally, a 404 Not Found error was encountered while trying to use an ErrorDocument to handle the request. "

[Link: remotecentral.com]

Still not working here.

I got into the www.iconharmony.com site after sever failed attempts yesterday. once you get in I suggest that you get all of the icons that you need or think that you need. I got into the site after 11 PM CST. also try http://www.lyngsat-logo.com for some channel icons

please redirect to my post in this thread:
[Link: remotecentral.com]

it seems to be working now, thanks a lot Randall

I'm just setting up my 1100 now, and downloaded icons for all the Australian free to air channels...I set them up on the favorites page and set the icons corresponding to their channel numbers (ie 7mate = 73), however when I press the 7mate icon, the remote only selects the first digit of each channel....

So basically pressing the 7mate button will go to channel 7, as will pressing the 7TWO button. Pressing the Ten button will go to channel 1, and so on..

How do I go about making the buttons go to their respective channels?

It sounds like the repeat and/or inter-key delay settings may need to be tweaked. Check out this link for more info.
These settings can be changed via the Harmony Remote software. Search 'delays' from the tip center's 'support' button on the right sidebar of the gui.

Thanks for the reply..

I played with the inter-key settings today after going through the FAQ for an answer, and managed to get it to work on the TV downstairs (Samsung LCD), so I thought I had it sorted...Tried it on my TV (Samsung LED), as the standard remotes are interchangeable, yet on my TV it still won't work!

I started at 100ms inter-key delay which worked fine on the downstairs LCD, and got up to 1000ms yet it still won't work on the LED!

I'm still fiddling with the delays but I'm all out of ideas, so really hoping someone else knows the problem and has a solution for me!

Scratch that!

I just changed the second delay option to greater than the inter-key delay and got it working!

Now just to play around with the two delays to get the channel change time down to a minimum and I'll be happy!

excellent. it took me a few days and going back for 3-4 tweaks to get my cisco dvr changing channels fast enough to my satisfaction. glad you have it sorted!