I have a problem with TV Input Selection after turning off the system with a different input selection selected.


Remote: Harmony 1000
TV: LG (42LC7D)


I have 2x activities setup which use my tv:
1) Watch TV (uses Component1)
2) Watch DVD (uses HDMI1)

Switching between the two works perfectly using the "activities" button.

However, if I turn off the system after watching tv (and therefore in component mode) next time I turn on the system and want to watch DVD as the first activity, everything turns on ok BUT the tv is still set to component and not HDMI.

If I press help, and go through the screens, I get to
"Is the TV set to the HDMI1 input?"
Choosing "NO" fixes the problem.

The same thing happens in reverse for the dvd (ie it wont set to Component and I have to use the help screens).


If there a nice solution to this?

Try altering the TV's power on delay in the Harmony software. It's likely that the input select codes are being sent before the TV is ready to receive them.
My Panasonic TV takes around 10 seconds from power on before it's ready to receive any commands.

ditto

Worked like a charm. Thanks.

I have another small thing to change (new thread) and then I will be content.