Post 1 made on Thursday October 9, 2008 at 12:27 |
OK, I'm stumped. I have a HK-TC30 and Harmony 620. My Harmony is updating fine but my HK-TC30 has stopped working. I get the error "Error Sending Data" message. I have disabled firewall software, etc (non of this has changed BTW since it last worked). I can't remember if I ever tried it after I upgraded to the Linksys Wireless N router. I've logged into the router and I don't see where anything is being blocked but I could be wrong. Any techies out there who might have ran into this?
|
|
Post 2 made on Thursday October 9, 2008 at 18:52 |
jlet Super Member |
Joined: Posts: | March 2004 2,631 |
|
|
I think you have to use the HK website interface ( http://www.mactc30.com/) for the HK-TC30. See the last few posts (around 53) of this thread: [Link: remotecentral.com]
|
H659, H680, SA8300HD, TH-50PZ850, AVR-X4000 |
|
OP | Post 3 made on Friday October 10, 2008 at 09:35 |
Hmmmm I know I have used the regular software not that long ago, I tried the web site as well yesterady and was getting the same error. I'll read through the post mentioned above and try again. Thanks!
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.