| Post 1 made on Tuesday March 6, 2007 at 18:46 |
ironman Long Time Member |
Joined:
Posts: | April 2003
70 |
|
|
I have two DirectTV boxes in my living room -- a HDDVR HR20-700S and an HD tuner H20-100.
PROBLEM: These two units use the EXACT SAME OEM remote. This means that one remote sends the same commands to both units.
DIRECT TV's solution is to program one of the units to respond only to commands sent in the "AV1" mode on the remote. That works just fine and is easy to do.
ISSUE: I cannot figure out how to program the Harmony 670 to control the H20 unit in "AV1" mode. It will only dowload the "DirectTV" command set.
Clearly, the IR codes for the DTV and AV1 modes are different, and the receiver is designed to work on one or the other, but I have no idea how to specify the AV1 code set using the website -- OTHER THAN LEARNING. I hate having to resort to that, I greatly prefer the computer programming method.
I would know exactly what to do with a JP1 capable One for all Remote, but I am new to Harmony.
Suggestions?
|
|
| Post 2 made on Tuesday March 6, 2007 at 20:00 |
akirby Super Member |
Joined:
Posts: | March 2004
4,640 |
|
|
Confirm IR Language under each device using the correct OEM remote. It will ask you to press a few buttons which it will use to determine the correct address (AV1 for the HR20).
|
|
| OP | Post 3 made on Wednesday March 7, 2007 at 22:53 |
ironman Long Time Member |
Joined:
Posts: | April 2003
70 |
|
|
Worked perfectly, thank you very much.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
