Post 1 made on Friday March 2, 2007 at 17:01 |
TommyV Long Time Member |
Joined: Posts: | November 2006 25 |
|
|
I have programmed my favorite channels on my Harmony for my HR20 in and everything works fine except for one, an XM music station. All my my other channels are 2 or 1 digit station numbers but the XM station is in the 800s. For some reason when my HR20 is on a 3 digit station and you push another station number like 4 and then the select button it brings up the info page for the channel you are on. This problem does not happen with 1 or 2 digit stations. So this brings the problem for the Harmony to switch back to a different favorite channel once Ive gone to a 3 digit channel.
If there was a way I could get it to not hit Select after entering the channel number it would be fine. Like if it could enter just 004 or even just 4 because the station changes fine then. Any thoughts?
|
|
Post 2 made on Saturday March 3, 2007 at 13:14 |
jlet Super Member |
Joined: Posts: | March 2004 2,631 |
|
|
Check the "How do you select channels" setup under "Device > More Options > Redo initial setup for this device (or Advanced setup...)". It has 4 options: 1 Two Numbers 2 Three numbers 3 Number(s) and then Enter or Select 4 Number(s) only If you selected the 3rd option, then it will also have asked what command to use for the Enter/Select function.
|
H659, H680, SA8300HD, TH-50PZ850, AVR-X4000 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.