| Post 1 made on Friday January 12, 2007 at 20:06 |
I've been troubleshooting my 890 for about an hour now and I'm stumped. Everything worked fine until last night, when the master "off" button failed to turn anything off. Tonight, nothing is receiving any commands with the exception of my X10 IR light controller and HTPC IR receiver. I updated my configuration about three days ago, but I tested everything and it has worked perfectly until now. To double-check, I made sure all firmware, software, and configuration was up to date. Sure enough, everything completed just fine without any errors. I should stress that my devices are not receiving any commands via IR or RF (with the exception of the X10 and HTPC, of course).
Does anyone know what might be going on here?
|
|
| Post 2 made on Tuesday January 16, 2007 at 15:28 |
ronterry Lurking Member |
Joined:
Posts: | December 2006
4 |
|
|
Did you try removing the battery to reboot the remote?
I noticed little things like disabling the tilt sensor causes the remote to basically act fruity, and requiring reboots often. This tells me there's still little beta left in 890.
Ron
|
Ron |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
