Hello!

When the "Watch DVD" activity is selected, my TV doesn't seem to like
being powered up, set to the DVD
input, BEFORE THE DVD PLAYER HAS POWERED UP: the TV thinks there is
no incoming signal and displays only a black screen [even after the
point where the DVD player is actually playing a movie]. A power
cycle for the TV takes care of the problem in the short term.

But in the long term, I need to change the SEQUENCE of the PowerUp
commands.

Ideally, when I press the WATCH DVD button, the following things
should happen in this order:
(1)DVD player turned on;
(2)Amplifier turned on;
(3)Amplifier switched to the DVD input;
(4)Perhaps a brief delay of 1-2 seconds(to give the DVD player time
to boot-up)
(5)TV turned on;
(6)TV switched to the DVD input.

Currently I know of know way of doing this. Any ideas?

Thanks