Your Universal Remote Control Center
RemoteCentral.com
Blu-ray & DVD Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
Sony cx-995v Laser replacement DBU-3 Instruction Not Clear
This thread has 4 replies. Displaying all posts.
Post 1 made on Sunday June 7, 2015 at 19:15
Devoir
Long Time Member
Joined:
Posts:
January 2009
19
I have a few Sony cx-995v units one of them has started failing to read some disc that I put in the unit. Doesn't matter if they are new or backups. The unit only had 2800 hours according the the usage log found by entering the "Start Testing Mode" b pressing Top Menu, Clear, Power in sequence.



I searched this forum and found a discussion on replacement laser DBU-3. I ordered it from AliExpress.com The unit per it's label the same model as the one I removed...


I installed the laser in the player however the laser doesn't emit any light like the original nor does the disc spin. I removed the unit and reinstalled the old unit. It spun the disc and emitted light. I swapped back and forth a few times with same result..

Looking at the AliExpress.com website there is a vague instruction.

Since the laser diode of this parts assembly is treated to prevent itself from electrostatic breakdown,make sure to remove the solder.


Can anyone explain where to remove solder or share what they did to get their replacement laser unit working ????
Devoir
Post 2 made on Monday June 8, 2015 at 00:02
edmund
Elite Member
Joined:
Posts:
April 2002
13,488
Try asking here:

[Link: hifi-remote.com]
OP | Post 3 made on Monday June 8, 2015 at 22:08
Devoir
Long Time Member
Joined:
Posts:
January 2009
19
Edmund, many thanks I will try there
Devoir
OP | Post 4 made on Thursday June 11, 2015 at 21:32
Devoir
Long Time Member
Joined:
Posts:
January 2009
19
If anyone has a picture or photo of the location of the solder pad I would appreciate it...... So far no luck on any forum
Devoir
Post 5 made on Saturday January 27, 2018 at 22:44
MrWizard
New Member
Joined:
Posts:
January 2018
1
I'm in the process of replacing the laser on this unit myself, and according to the sony service manual for this product, on one of the boards on the laser unit, there should be two fairly large solder points between the two ribbon cables on the board. The blueprint has the solder point location labeled as "SL001," but i have not confirmed this label on my unit yet. According to the manual, when you solder those two points together, it protects the board from ESD (electro-static discharge). The manual recommends soldering those two points together during service. Then, after servicing, but prior to testing, you MUST remove the solder from those points. Failure to do so may (probably will) result in inoperation of the unit.

Had I not just read that part in the service manual, i wouldve been confused by that instruction too.

I hope this helps. PM me your email if you'd like me to send you a screenshot of the section of the service manual that shows this. It might help with the location of the two solder points on the board.


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse