Post 1 made on Tuesday June 9, 2020 at 07:36 |
Pambs Long Time Member |
Joined: Posts: | January 2007 54 |
|
|
Hi Guys
I am trying to get the codes for this Matrix unit. It's 4 in 4 out. I obtain the codes with the Pronto IR reader but nothing is working and i do not understand why since the unit's remote is very basic and just let's you select the inputs / outputs
Does anyone have the codes? or any idea what might be the problem?
thanks Charalambos
|
|
OP | Post 2 made on Sunday June 14, 2020 at 12:45 |
Pambs Long Time Member |
Joined: Posts: | January 2007 54 |
|
|
I am trying to connect it through RS232. I have used a 3pin phoinix connector and included the commands like the below
RS232 Commands The SY-MUHD-44 and SY-MUHD-88 can also be controlled using RS232 commands, and some configuration settings can only be performed using RS232 commands. The same commands can sent to the matrix via the Ethernet, as IP commands.
The serial port settings should be set to: 57600,n,8,1 (baud: 57600, no parity, 8 data bits and 1 stop bit) with no handshaking.
In each of the following RS232 command the symbol represents the carriage-return character (0x0d). Where shown for a particular command, the square brackets [] are required for that command. The commands normally reply with the same command that was sent, but with the fist character pointing left: e.g. the command: >@WVSO[1]I[2] gives the command response: <@WVSO[1]I[2] Video Selection Commands Change the input and output signal routing: Where x is the input number and y is the output number. >@WVSO[y]I[x] Set input x to all outputs >@WVSOA[x] Turn output y off >@WVSO[y]OFF Turn output y on >@WVSO[y]ON
Do i need to add something more on this code? Because still is not responding. Added it as ASCII
>@WVSO[1]I[2]
|
|
OP | Post 3 made on Wednesday June 17, 2020 at 04:57 |
Pambs Long Time Member |
Joined: Posts: | January 2007 54 |
|
|
Hi
can someone move this to the RS-232 & IP Control section since i am trying with RS now
|
|
OP | Post 4 made on Saturday June 20, 2020 at 16:43 |
Pambs Long Time Member |
Joined: Posts: | January 2007 54 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.