|Post 1 made on Friday April 22, 2011 at 15:18|
I have a motorized lift with hex codes they provided me but I can't use them in CCP. I have no means or the no-how on how to change them. Can some one please convert to something I can use in CCP?
Up= FF 02 5F XX
Stop= FF 02 3F XX
Down= FF 02 4F XX
Thanks in advance!!
|Post 2 made on Friday April 22, 2011 at 20:22|
We need more info.
Are these IR codes or RS232?
If IR what IR Protocol are they using?
|OP | Post 3 made on Saturday April 23, 2011 at 11:03|
Its an AVAD PROconnect lift made by Elevan, I hope I got the name right, and they are IR. Thats all I know. On the front of the manual, they list the hex code, as I have posted above, and a binary code. Thats it. They provide no other info.
I tried calling AVAD and they were no help. I tried calling the number listed in the manual for tech support and the number was out of service and AVAD had no cantact info on this company. I called URC and they told me I needed to convert to Pronto hex. I also called Phillips and they were no help. Then I tried to download Pronto software to see if I could use that and I can't get cause we are not an Authorized dealer. So, this leaves me really screwed at the moment!
|Post 4 made on Saturday April 23, 2011 at 22:39 |
Can you post the rest of the info you have?
We need to know what IR Protocol
they are using or a learnt hex code from the remote to generate the hex codes. Without this info it is impossible to help.
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.